I think the sprinkler line in the left corner of. It all started when I noticed that there was a patch of my grass that I thought was diseased. A compression repair coupling is one option for repairing a broken sprinkler water line. Using a compression coupling doesn’t require measuring, gluing, or any additional space. Note: compression couplings cannot. Keywords: repair a lawn sprinkler hose line, hose repair kit, utility knife, hose clamps, hose barb. Hi, I'm Dave Cordone from Absolute Custom Landscape for About.com. Today, I'm going to show you how to change out a sprinkler head including all the tools and parts you'll need to do the job. Sprinkler Head Supplies The parts.
Typically this repair is done by cutting out the broken section and replacing it with a larger diameter piece. One thought on “ Repairing a sprinkler line ” July 31, 2015. Fixing Cracked PVC Under Concrete. There are ways you can do it. I dont think it is possible for you to fix the actual crack,you would have to feed a new sprinkler line under. How to Fix a Broken Sprinkler Pipe. You might be able to patch the leak, rather than replace the pipe. See eHow's tutorial on patching inground lawn sprinklers. If you're at all concerned with repairing the leak yourself. Http:// Did you just hit on of your buried sprinkler lines with your shovel? If your irrigation system is made with black pipe (polyethylene) then it's a quick and inexpensive fix. How do I repair a punctured sprinkler line? I found a hole in the sprinkler line. Are you sure you want to delete this answer? Is there a way to patch a cracked PVC irrigation pipe?
How to Repair a Sprinkler Line. Turn off the water supply to the line and excavate the area around the break, giving yourself a work area of about 1 foot on each side and a few inches underneath.
Use the hacksaw or PVC saw to cut away the damaged section of pipe. Do this by cutting on both sides of the break at the last point that is in good condition. Discard the broken piece. Start on either end of the line and clean the pipe surface thoroughly. Put a coat of PVC primer on the end of the pipe, then add a generous amount of PVC cement to the inside contact area of the coupling.
Slide the coupling onto the end of the pipe. Measure the gap between the end of the coupling and the other end of pipe. Cut a piece of PVC pipe to this length, then attach another coupling to the other end of pipe using the same process as Step 3. Apply PVC primer to the end of the replacement pipe, add a layer of cement to the contact area inside the coupling and slide the replacement pipe in. Repeat for the other side. Test the repair by running the system, then fill in the excavated area.